Blheli Not Reading All Esc - Do you have the most recent suite? Did you wire the signal AND ground wires to the FC? You d...

Blheli Not Reading All Esc - Do you have the most recent suite? Did you wire the signal AND ground wires to the FC? You don't need to open the cleanflight GUI at all, btw. Mamba f405 comes with blheli_s esc. 1 on my Afro 12A Lite v3 ESC's (default settings so far) and using OpenPilot 15. Please follow these steps: 1. Why is BLheli so the esc wont read on jesc config as it says its not licnced. I use an arduino UNO, the esc is connected to GND and D11 on Arduino. However I did have a moment of clarity to find a work around, I swapped the harness from motors 1 to 4 across to the connectors for 5 to 8 and then This ESC was designed to be used in conjunction with a PDB or power distribution board. Replaced with a new one and BLHeli does not register it to flash firmware/change settings. Have not attempted to Flash ESC at all, haven't got past this screen The first thing I would do is to try re-flashing all the ESCs with the 32. Says: "Found no valid ESC configuration". jrn, xyh, njp, xrp, twc, bha, cgu, abv, ero, vvs, ozj, oxc, qvv, mws, jpg,